Sorry, this page is not translated yet. Automatic translation used.
The electric player "Phoenix-006-stereo" from 1981 to 1987 included the Lviv telegraph equipment factory. The high-end stereo stereo electric player '' Phoenix-006-stereo '' is designed for high-quality playback of mechanical recordings from records of all formats. There is no technical description of the EP yet, but there is a note about the model of the author of the photographs of Alexander Maistrenko from Zaporozhye: The Silent Electric Player Tonarm. Compensator of rolling force - spring. There is a useful and rare function of tonearm adjustment in height within 7 mm. In the vertical plane, the arm is suspended on 2 precision ball bearings. In the horizontal - on one. They are adjusted by distance, pressed and flared, so there is no backlash. In the tonearm, 4 wires of 7 conductors of 0.07 mm each of the type "litze-wire" were used as a signal wire. The same wire grounded tube tonearm. Automatics EP electronic. Hitchhiking is performed on a reed switch with a sensor in the form of a permanent magnet on the swivel arm of the arm. An alternating current motor with a gear reduction gear is responsible for moving the tonearm. The motor is connected with the control levers of the tonearm via a drum with a connecting rod mechanism. On the drum there are protrusions that switch the limit switches, carrying out this or that type of work of the EA. Direct drive motor, eight pole with 4-pin Hall sensor. For the operation of the engine, the generator board is used at the OS and transistors. An eight-pole motor sets in motion a permanent magnet rotor part. The rotor is supported by an insert of high-strength steel on the heel of fluoroplastic (caprolon?), Which provides a friction coefficient lower than the metal-to-metal pair. In the radial plane, the rotor is mounted on a plain bearing. The quality of the fit is so high that if you insert the rotor without a magnet vertically into the bearing and let it go, it does not fall, but slowly falls. The engine with the tonearm is mounted on a 40 mm thick chipboard with a steel counterweight.The plate is attached to the body at 3 points on the shock absorbers, which ensures good vibration isolation from the body. The shock absorbers are adjustable in height, which makes it possible to set the plate with the arm and the engine parallel in the horizontal plane, by simple adjustments. The weight of a disk is 1,5 kg. The weight of the rotor with a magnet and disc is 3.8 kg, which b-well affects the stability of revolutions. The upper part of the EP is made of cast aluminum alloy and painted with matte paint about 1 mm thick. The weight of the device is 14.7 kg. In general, the culture of production apparatus is very high. In my opinion, the EDS exceeds the level of the B1-01 Electronics. The device is quite rare. On all components of the rack known to me, the numbers did not exceed 1000. On my motor no. 666, chassis 786. The 020 figures are present at the beginning of the numbers of all the devices I know and represent the factory cipher. My EP - 1986.